|
Network Discovery Wizard
|
The network discovery wizard takes you through the following steps:
When the application starts, you will have the option to start the discovery wizard, load the sample monitor list, or click cancel to go right to the console.
Configure the account that the service should run under
Select the type of discovery, ip address range, ip address range with SNMP, or the network neighborhood
If you opted to create a new monitor list, then you will be prompted to for a new file name for the list
Add the IP ranges that should be scanned or select the devices from the network neighborhood
Select the monitors that should be detected during discovery
Configure the monitors that were selected
Discovery runs
The devices that were detected are presented with a list of monitors that are available for the device, select the devices that you want to create monitors for
The monitors will be added to the console and a message will be displayed when it is finished.
|
|
|
 |
